What To Do If - Electrolux EKM601101 User Manual

16 electrolux
6. place it on a steady plan.
Important! Clean the oven door glass with
warm soapy water and a soft cloth only.
Never use harsh abrasive.
Once the cleaning is carried out, refit the
oven door, following the procedure in re-
verse.
Warning! Do not clean the oven door
while the glass panels are warm. If this
precaution is not observed the glass
panel may shatter.
If the door glass panel becomes chipped
or has deep scratches, the glass will be
weakened and must be replaced to pre-
vent the possibility of the panel shatter-
ing. Contact your local Service Centre
who will be pleased to advise further.
Oven shelves
Warning! Before proceeding ensure the
oven is cool and disconnected from the
electricity supply.
To clean the oven shelves, soak in warm
soapy water and remove stubborn marks
with a well wetted soap impregnated pad.
Rinse well and dry with a soft cloth.
Controls - sundries
Periodically check the condition of the flexible
pipe of gas connection and make it replaced
by skilled technicians as soon as it shows
abnormalities. Annual replacement is recom-
mended.
Oven lamp replacement
Warning! Disconnect the appliance
from the electricity supply.

What to do if...

If the appliance is not working correctly, please carry out the following checks, before con-
tacting your local Service Centre.
Symptoms
There is no spark when lighting the gas
If the oven bulb needs replacing, it must
comply with the following specifications:
electric power, 15 W /25 W; electric rate, 230
V (50 Hz); resistant to temperatures of 300
C; connection type: E 14. These bulbs are
available from your local Service Force Cen-
tre.
To replace the faulty bulb:
1. Ensure the oven is disconnected from the
electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace it with
the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.
Solutions
• check that the unit is plugged in and the elec-
trical supply is switched on
• check the mains fuse has not blown
• check the burner cap and crown have been re-
placed correctly, e.g. after cleaning
°