Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG Electrolux LAVATHERM 7021 TK ELECTRONIC
Summary of Contents for AEG Electrolux LAVATHERM 7021 TK ELECTRONIC
- Page 1 LAVATHERM 7021 TK ELECTRONIC Condensation dryer User Information...
-
Page 2: Dear Customer
Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appli- ance. The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. -
Page 3: Table Of Contents
Contents Instructions for use ........Safety . - Page 4 Installation and connection instructions ....25 Installation safety instructions ........25 Removing transport safety equipment .
-
Page 5: Instructions For Use
Instructions for use 1 Safety Before first starting up • Note the ”Installation and connection instructions” • Before first starting up, check the machine for any damage incurred during transport. Never connect up a damaged machine. If parts are damaged, contact your supplier. Intended use •... -
Page 6: Disposal
• Clean the heat exchanger regularly. • With stacked washer and dryer: Do not place objects on the dryer. These may fall off during operation. • The covering bonnet of the bulb for the drum light must be screwed down tightly. Child safety •... -
Page 7: Environmental Tips
Old appliance The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of elec- trical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. -
Page 8: Description Of Machine
Description of machine Drawer containing Operating screen condensate tank Fine strainer (lint filter) Lamp for inside light Large mesh filter Micro-fine filter (lint filter) (lint filter) Type plate Loading door (interchangeable Base door stop) upstream of Screwed feet heat exchanger (with height adjustment) Air slots... -
Page 9: Before The First Drying Cycle
Before the first drying cycle In order to remove any residues which may have been produced during production, wipe the dryer drum with a damp cloth or carry out a brief drying cycle (20 MIN) with damp cloths in the machine. Sorting and preparing laundry Sorting laundry •... -
Page 10: Programme Overview
Programme overview Additional functions Care Programmes Application/properties symbols EXTRA DRY Thorough drying of thick or multi- [EXTRA- • • • layered fabrics, e.g. terry towelling TROCKEN] items, bathrobes. INTENSIVE DRY Thorough drying of thick fabrics, [STARK- • • • e.g. terry towelling items, towels. TROCKEN] STORAGE DRY Thorough drying of fabrics of even... - Page 11 Additional functions Care Programmes Application/properties symbols 20 MIN For drying individual items of laundry or • • 40 MIN for small volumes of less than 1kg. Special programme with anti-crease mech- anism for easy care fabrics such shirts and blouses; for minimum ironing effort. The result depends on the type of fabric and its EASY IRON finish.
-
Page 12: Drying
Drying Switching machine on / switching light on Turn the programme selector to any programme or turn it to LIGHT (BE- LEUCHTUNG). The machine has been switched on. When the loading door is opened, the drum is illuminated. Opening loading door / loading laundry 1. -
Page 13: Audible Signal (Signal)
AUDIBLE SIGNAL (SIGNAL) When the drying cycle has finished, an intermittent audible signal will sound. SPECIAL CARE (SCHON) For especially gentle drying of sensitive fabrics with the l care label and for temperature-sensitive textiles (e.g. acrylic, viscose). Programme is executed with reduced heat. SPECIAL CARE (SCHON) is only suitable for use with loads of up to 3kg! SENSITIVE (SENSITIV) For gentle drying of frequently-worn textiles. -
Page 14: Starting The Programme
Starting the programme Press the START/PAUSE button. The programme is started. The programme progress display show drying progress. Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF (AUS) and then reset the programme. -
Page 15: Drying Cycle Complete / Removing Laundry
Drying cycle complete / removing laundry Once the drying cycle is complete, the END (ENDE) and CREASE GUARD (KNITTERSCHUTZ) displays light up. If the AUDIBLE SIGNAL (SIGNAL) button has been pressed, an audible signal sounds intermittently. The drying cycle is automatically followed by a crease guard phase which lasts around 30 minutes. -
Page 16: Cleaning And Maintenance
Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine fil- ter and fine strainer) must be cleaned after every drying cycle. Caution! Never operate the dryer without fluff filters or with damaged or blocked fluff filters. -
Page 17: Cleaning The Door Seal
Clean the entire filter area The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. 6. To do this, grip the top of the large mesh filter and pull it forwards un- til it comes loose from the two brackets. -
Page 18: Emptying The Condensate Tank
Emptying the condensate tank Empty condensate tank after every drying cycle. If the condensate tank is full, an active programme will break off auto- matically and the EMPTY WATER (BEHÄLTER) display will light up. In or- der to continue the programme, the condensate tank must first be emptied. - Page 19 1. Open loading door 2. Open base door. To do this, press the release button located beneath the loading aperture and open the base door to the left. 3. Remove lint from the inside of the door and the heat exchange cham- ber.
-
Page 20: Cleaning The Drum
Cleaning the drum Caution! Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. - Page 21 Problem Possible cause Remedy Select a different programme the next time you dry Wrong programme selected. (see “Overview of pro- grammes” section). Lint filter clogged. Clean lint filter. Heat exchanger clogged Clean heat exchanger. with lint. Observe recommended load- Drying results unsatis- Incorrect volume of laundry.
-
Page 22: Changing Bulb For Inside Light
Problem Possible cause Remedy Lint filter clogged. Clean lint filter. Heat exchanger clogged Drying cycle lasts an Clean heat exchanger. with lint. unusually long time. Note: SPECIAL CARE (SCHON) but- SPECIAL CARE (SCHON) is only After up to 5 hours the ton pressed and load vol- suitable for use with loads of drying cycle finishes... -
Page 23: Programming Options
Programming options Objective Implementation 1. Turn the programme selector to any programme. Permanently program 2. Press the AUDIBLE SIGNAL (SIGNAL) button and hold in the audible signal down for approx. 5 seconds. which reminds you that A brief signal sounds several times. The AUDIBLE SIGNAL the programme is com- (SIGNAL) display flashes several times. -
Page 24: Technical Data
Technical Data This appliance complies with the following EU directives: – 73/23/EEC dated 19.02.1973 Low Voltage Directive – 89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC – 93/68/EEC dated 22.07.1993 CE Marking Directive Height x width x depth 85 x 60 x 60 cm Depth with loading door open 109 cm... -
Page 25: Installation And Connection Instructions
Installation and connection instructions 1 Installation safety instructions • Before first starting up, all parts of the transport safety equipment must be removed. The machine may otherwise be damaged. • Before starting up for the first time, ensure that the nominal voltage and type of current specified on the machine type plate match the nominal voltage and type of current at the installation site. -
Page 26: Removing Transport Safety Equipment
Removing transport safety equipment Caution! Before first starting up, all parts of the transport safety equipment must be removed. 1. Open loading door 2. Pull off adhesive strips from inside machine on top of drum. 3. Remove foil hose and polystyrene padding from the machine. - Page 27 1. Open loading door 2. Unscrew hinge A from the front of the machine and take off the load- ing door. 3. Remove cover plates B and C. To do this, insert a thin screwdriver into the slots as shown in the illustra- tion, press downwards slightly and pry out the cover plates.
-
Page 28: Special Accessories
These intermediate installation kits can be used to arrange the dryer and an automatic AEG-Electrolux washing machine (60cm wide, front loading) as a space-saving washer/dryer stack. The automatic washing machine is at the bottom and the dryer is at the top. -
Page 29: Customer Services
Customer Services Servicestellen Points de Service Servizio dopo vendita 5506 Mägenwil/Zürich 1028 Préverenges 6916 Grancia Industriestrasse 10 Le Trési 6 Zona Industriale E 9000 St. Gallen Vonwilstrasse 15 4127 Birsfelden Hauptstrasse 52 8604 Volketswil Hölzliwisenstrasse 12 6032 Emmen Buholzstrasse 7000 Chur Comercialstrasse 19 3063 Ittigen/Bern Ey 5... -
Page 31: Service
Service In the event of technical faults, please first check whether you can remedy the problem yourself with the help of the operating instruc- tions (section “What to do if…”). If you were not able to remedy the problem yourself, please contact the Customer Care Department or one of our service partners. - Page 32 USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg-electrolux.de © Copyright by AEG 822 944 765-01-210206-02 Subject to change without notice...