The Appliance Components - Silvercrest SPU 900 A1 Operating Manual

Warnings about interaction with
batteries
The appliance uses batteries for memory
storage. When handling batteries,
please observe the following:
• If you do not intend to use the appliance
for an extended period, remove the
batteries.
• Regularly check the condition of the bat-
teries. Leaking batteries can cause dam-
age to the appliance.
• Should the batteries leak, put on a pair
of protective gloves and clean the bat-
tery compartment and terminals with
a dry cloth.
Caution!
Never subject the batteries to excessive heat
(i.e. bright sunlight, fire, etc.).
Attention!
There is a risk of explosion if the batteries are
improperly replaced. Only replace with the
same or equivalent types.
Notice regarding separation
from mains-power
The button on this appliance does not
completely disconnect it from the mains
power network. Additionally, the appli-
ance consumes power when in standby-
mode. To completely separate the appli-
ance from mains power, the plug MUST
be removed from the wall socket.
Notice regarding electrical
power surges (EFT / electrical
fast transient) and electrostatic
discharges:
In a case of malfunction due to an elec-
trical fast transient (power surge) and/
or electrostatic discharge, the appliance
must be returned to default settings in
order to re-establish normal operation.
This could mean that it must be discon-
nected from the power supply and then
reconnected. The batteries (if present)
must be removed and then reinserted.
Notice
No liability/warranty claims will be con-
sidered for damage to the appliance
caused by the effects of moisture, water
penetration, overheating or due to un-
authorised modifications!
The appliance components
q VOL—
w VOL +
e MODE/LOCK - Recalls the adjustable
r Loudspeaker
t Projektor
y SNOOZE/
DIMMER
u BAND
i DOWN

o UP

a PROJECTION
s PRESET/ALARM + - Radio station/alarm
d PRESET/ALARM – - Radio station/alarm
f PAGE/AL.SET
g Display
h A.M.S. MEMORY - Autom. radio station
j SLEEP
k NAP/USER
l
- 4 -
- Volume decrease
- Volume increase
parameters/Button lock
- projects the time onto
a wall
- Snooze button,/
Brightness switch
- Switches the radio wave-
band
- Selector button down-
wards
- Selector button up-
wards
- Time projection on/off
switch
memory upwards/
memory downwards
- switches the memory
sides/calls up the
alarm function
- Indicator
save
- Controls the switch-off
timer
- User switching, Timer
function
- On/Off switch for
radio functions