Table of Contents
Advertisement
Connecting the MCU 53x0
Connecting the MCU 53x0
Before you start
IMPORTANT: Before installing the MCU 53x0, you must read the safety information at
http://www.cisco.com/go/telepresence/safety.
Task 1: Connect power
Connect the power connector on the rear of the unit to the power supply using the supplied power cable.
(There is no On/Off switch.)
Task 2: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch.
Failing to configure both sides of the Ethernet connection in the same way can result in packet loss,
i
leading to poor audio and video quality.
Only connect to Ethernet Port B if you need to connect the MCU to a second subnet.
Cisco TelePresence MCU 5300 Series Installation Guide
Page 5 of 14
Advertisement
Table of Contents
