Download  Print this page

The Refrigerator Or Freezer Needs Air; Appliance Alignment; Electrical Connection - AEG A 75210 GT Operating And Installation Manual

Chest freezers “ no frost”
Hide thumbs

Advertisement

The refrigerator or freezer needs air.

The side walls become warm whilst the appliance is on. The heat is generated by
the special refrigerating system (shell condenser) and prevents condensate and
thus rust from forming on the side walls. In order for the heat to be able to be
dissipated, air must be able to circulate around all the side walls.
Attention! To function correctly the appliance requires good ventilation. Make
sure that the side walls and the base of the appliance are not covered or
obstructed.

Appliance Alignment

The appliance must have a solid, level footing. Please compensate for
uneven floors with appropriate supports.

Electrical Connection

Warning – this appliance must be earthed
Please ensure that the voltage and current indicated on the rating plate agree
with the voltage of your electricity supply.
220/240 volts (i. e. 220/240V AC).
If your appliance has been equipped with a mains lead with a moulded on type
plug, you must comply with the following regulations:
The plug moulded on to the cord incorporates a fuse. For replacement, use a 13
amp BS 1362 fuse. Only ASTA approved or certified fuses should be used. The fuse
cover/carrier must be replaced in the event of changing the fuse. The plug must
not be used if the fuse cover/carrier ist lost. A replacement cover/carrier must be
obtained from an electrical goods retailer. If the socket outlets in your home are
not suitable for the plug fitted to the appliance, then the plug must be cut off and
an appropriate one fitted. When fitting the plug please note the following points:
Important
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow
Blue
Brown
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings indentifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow must be connected to the earth
terminal in your plug, which is marked with the letter E or by the earth symbol
or coloured green, or green and yellow.
2. The wire which is coloured brown must be connected to the live terminal which
is marked with the letter L or coloured red.
Earth
Neutral
Live
27

Advertisement

loading

This manual is also suitable for:

A 75240 gtA 75310 gtA 85210 gtA 85240 gt