Installing And Connecting; Installation; Appliance Alignment - AEG COMPETENCE 5003 F Operating Instructions Manual

Electric free-standing cooker
Table of Contents

Advertisement

Installing and Connecting

INSTALLING AND CONNECTING
Important: Assembly and connection of the new appliance may only
1
be performed by an approved installer.
Please observe this instruction, otherwise the warranty will not cover
any damage that may occur.

Installation

Important Information
• The veneer or plastic coverings on kitchen furniture around the
appliance must be bonded with heat resistant adhesive (100 °C). If
plastic coverings or the adhesive are not sufficiently temperature
resistant, then the covering may distort or come loose.
• In respect of fire protection, this appliance corresponds to type Y
(EN 60335-2-6). Only this type of appliance may built into positions
with a high cupboard or wall on one side.
• The separation between the hob and the extractor hood must be at
least as large as that given in the extractor hood installation instruc-
tions.

Appliance Alignment

Underneath the appliance there
are 4 adjustable feet with the aid
of which you can compensate for
small amounts of unevenness in
the floor.
1. Remove the utensils drawer
0
2. Turn the adjustable feet to raise
or lower them until the cooker is
level.
3. Replace the utensils drawer.
The adjustable feet are easier to
3
turn if the cooker is tilted slightly
to take the load off the feet.
38
_
_
+
+

Advertisement

Table of Contents
loading

Table of Contents