Cleaning And Care; Hob - AEG COMPETENCE 5003 F Operating Instructions Manual

Cleaning and Care

Hob

Clean the hob and the cast hotplates after each use, when they are still
3
warm to the touch or cold. By this means you will avoid spills becoming
burnt on.
Decorative Lid
You can remove the decorative lid to clean the hob.
0 1. Open the decorative lid fully so that it is vertical.
2. Remove the cross-head screws on the right and left.
3. To replace, fit the decorative lid such that it is vertical and fix in place
with the two cross-head screws.
Caution: Only close the decorative lid when the rings have cooled
1
completely! There is a risk of burns!
Cast Hotplate
0 1. Remove heavy soiling with fine scouring sand or a scouring pad.
2. Wipe away residues with a damp cloth.
3. Then warm the hotplate a little and leave to dry.
4. To maintain the cast hotplate in good condition, occasionally rub a lit-
tle sewing machine oil into it and then polish with absorbent paper.
(Do not use butter, bacon fat or similar substances for this purpose!)
Important: Do not use scouring sand or a scouring pad to clean the
1
stainless steel surround on the hob because these cause scratches!
General information
3
• After cleaning, heat the hotplates briefly to dry them.
• Do not place moist or wet items on the hotplates.
• Rub utensils dry before placing them on the hotplates.
• Due to the thermal load during cooking, the stainless steel surround
on the hob may discolour slightly. This is due to physical reasons.
Operating Instructions
29