Table of Contents
Advertisement
6 electrolux
Installation
INSTALLATION
Drilling the Support surface and
Fitting the Hood
SCREW FITTING
EN
• The hood support surface must be
135 mm above the bottom surface of
the wall units.
• Drill the support with a ø 4,5 mm drill
bit, using the drilling template pro-
vided.
• Cut a hole ø 125 mm in size on the
support surface, using the drilling
template provided.
• Fix using the 4 screws 12a (4,2 x
44,4) provided.
SNAP-ON FITTING
• The hood can be installed either di-
rectly on the bottom surface of the
wall units using snap-on side sup-
ports.
• Cut a fitted opening in the bottom
surface of the wall unit, as shown.
• Insert the hood until the side supports
snap into place.
• Lock in position by tightening the
screws Vf from underneath the hood.
CLOSING ELEMENT
• The space between the edge of the
hood and the rear wall can be closed
by applying the element 20 provided,
using the screws supplied for this pur-
pose.
���
���
���
��
���
��
���
��
��
Hide quick links:
Advertisement
Table of Contents
