AEG COMPETENCE B1180-4 User Information page 38

Cleaning the door glass
Clean the door glass thoroughly with a solution of water and washing
up liquid. Then dry it carefully.
Putting the door glass back
1. From above insert the door glass at
an angle into the door profile at the
bottom edge of the door and lower
it.
2. Take hold of the door trim (B) at
each side, position it on the inside
edge of the door and plug the door
trim(B) into the upper edge of the
door.
3
On the open side of the door
trim (B) there is a guide bar (C). This
must be pushed between the outer
door panel and the guide corner(D).
The clip seal (E) must be snapped in.
38