Drying Sequence - Electrolux EDC 505 E Installation And Instruction Manual

i

Drying sequence

Before starting up for the first time it is advisable
lo load a few moist cloths into the dryer and to let
it run for about 20 minutes. This ensures that no
dust and dirt is left in the drum.
Drying
1. Connect the tumble dryer
2. Load the items one at a time, shaking them
out loosely.
3. Close the door
4. Select the drying programme or time: the
mains-on light illuminates.
5. If necessary, press button
6. Press START-button: the drying cycle starts
and light illuminates.
All drying programmes end with a 9-minute
cooling phase (light
If you do not remove the laundry at the end of the
programme, the machine will perform the anti-
crease phase which lasts 30 mins. max.
If you have not depressed button
will sound every 10 seconds, the lights
will flash alternatively. To remove
the laundry at this stage, turn the selector dial to
"0", the mains-on light goes out.
If you do not remove the laundry during the anti-
crease phase, the appliance will stop
automatically at the end of this phase: the mains-
on light will remain lighted and the control lights
and will continue to flash.
After each drying cycle
Turn the programme selector dial to "0" to
switch the dryer off
Empty the water container and clean the filter
(see following pages)
58
or
.
is on).
, the buzzer
and
M0028
P0885