Maintenance And Cleaning; Fluff Filter; Water Container; External Cleaning - Electrolux EDC 503 M Instruction Booklet

Hide thumbs Also See for EDC 503 M:
Table of Contents

Advertisement

Cleaning fluff filter
Clean fluff filter located on the inside part of the door
after every drying programme.
Proceed as follows:
Pull filter upwards in order to remove it.
Remove fluff from filter by hand or with a damp
cloth.
Place filter in original position.
Emptying water container
Water extracted from the laundry being dried is
collected in a special container. This container must
be emptied after every cycle, but it can also be
emptied during the drying cycle. Should you forget to
empty the container, a light will light up on the panel
and the drying cycle will stop automatically even if
the laundry is not dry yet. Insert container correctly.
Cleaning tumble dryer
The external part of the appliance, the control panel,
the drum, its plastic and rubber surfaces may be
cleaned with a damp cloth and neutral washing-up
liquid.
Cleaning inside part of drum
Should a film of limescale build up on the drum after
a while, remove it with a damp cloth and a limescale
remover.
ATTENTION! Do not use solvents or abrasive
substances.
Cleaning condenser
Remove fluff from condenser on a regular basis to
avoid prolonging drying times and increasing energy
consumption.
Proceed as follows:
1. Remove condenser by using the top handle.
2. Clean condenser with a hand-held shower or a soft
brush.
3. Clean external part, too.
4. Leave condenser to dry; when it is dry, place in
original position.
Important! Do not use pointed objects or utensils to
clean the spaces between the plates, as this could
damage the condenser and make it permeable.
Do not use this appliance if the condenser has not
been fitted.
22

MAINTENANCE AND CLEANING

P1026
C0033
P0636
P0827
P0639

Advertisement

Table of Contents
loading

Table of Contents