Table of Contents
Advertisement
Installation proud of the
work surface
Sticking on the seal
• If installing proud of the work sur-
face, use the sealing tape with di-
mensions 16x2 mm.
• Clean the worktop in the area of the
cut-out.
• Cut the one-sided self-adhesive
sealing tape supplied into four parts
according to the edge length of the
cut-out and stick to the worktop
along the edge of the cut-out.
• In doing so, the sealing tape should
protrude by approx. 3 mm over the
edge of the appliance on all sides.
installation proud of the work surface electrolux 25
• Do not stretch the sealing tapes
when sticking. Do not stick the ends
on top of each other, these should
be pushed against each other.
• After fitting the Teppan Yaki (using
the provided fitting material), the
overlaying sealing tape must be cut
away on all sides using a sharp knife.
Take care not to damage the work-
top.
Advertisement
Table of Contents
