To Avoid Breakage - Electrolux 318201631 Installation Instructions Manual

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or manipulate the
unit by the cooktop.
1
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1)
2
Before installing the unit,
measure the heights of
the two (2) cabinet sides
(H1-4), front and back
(see illustration 1) from
the floor to the top of the
counter.
3
Level the range using the leveling legs and leveling
device (if equipped) so that the height from the
floor to the underside of the cooktop glass frame is
greater than the tallest cabinet measurement by at
least 1/16" (0,16 cm) (see illustration 2).
4
Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center of
the cabinet cut-out.
5
Remove the protective channels on each side of the cooktop (if provided).
6
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The glass cooktop
should NOT directly touch on the countertop (see illustration 2) or
could cause glass breakage voiding the warranty. Level the unit if
needed.
7
After the installation, MAKE
SURE that the unit is
supported by the leveling
legs and NOT by the
cooktop.
Shave Raised
Edge to Clear
1 ½" Max.
Space for a
(3,8 cm Max.)
31 5/16" (79,5
cm) Wide
Cooktop.
5
H2
H4
H1
H3
Illustration 1
To successfully
install the
range, the
initial level
height from
floor to
underside of
cooktop frame
should be at
least 1/16"
(0,16 cm) taller
than cabinet
sides as
measured in
Illustration 2
step 2.