Use; The Control Panel - Electrolux EDC 510E Instruction Booklet

125992513 _1.qxp 2005-02-01

Use

The control panel

SENSOR PROGRAMMES
COTTON
Extra Dry
Ready to Wear
Store Dry
Slightly Damp
Iron Dry
Wring Dry
1 Programme Guide
This will help you to select the correct programme
for drying.
2 NO BUZZER button
A buzzer sounds
• when selecting the programme
• when depressing the buttons
• when an incorrect option selection is made
• when the programme selector dial is turned to
another position during the programme or when
you depress an option button during the cycle
• at the end of the programme and during the
anticrease phase
• when the water reservoir is full
• if the machine is not working correctly
• when the door of the appliance or the small door at
the bottom are open
By depressing NO BUZZER button the acoustic
signal is switched off in the same cases mentioned
above.
The corresponding light comes on.
3 QUICK button
By depressing this button the drying time is reduced
in the following COTTON programmes:
• EXTRA DRY (Progr A)
• READY TO WEAR (Progr B)
• STORE DRY (Progr C)
The corresponding light illuminates. This option
cannot be selected together with the LOW
TEMPERATURE function.
14:17 Page 8
CONDENSER DRYER
TIMED PROGRAMMES
SYNTHETIC 30 - 60 - 90 min
A Extra Dry G Dry Fresh L
B Store Dry H Cooling
J
C
Iron Dry
D Baby Dry K
E
F RESET O
1
Drying
Cooling
End
Clogged Filters
Full Tank
Clogged Condenser
2 3 4 5 6
4 LOW TEMPERATURE button
Pressing this button allows the drying of delicate
items at a lower temperature.
The corresponding pilot light comes on.
This option can also be used for time controlled
drying.
This function cannot be used with QUICK.
5 START/PAUSE button
Press this button to start the dryer after having
selected the programme and the options.
The relevant light will stop flashing.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the programme
from the point at which it was interrupted.
This button must be depressed also after a
power failure and after having re-inserted the
water reservoir, if it has been emptied in the
middle of a programme after lighting up of the
FULL TANK light.
In both cases the light of the Start/Pause button
flashes to remind you that the start button needs to
be pressed again.
8
PROGRAMMES EDC 510 E
0
H
7