Download  Print this page

Electrical Connection - Electrolux 65557 G-M Instruction Booklet

Hide thumbs

Advertisement

16

Electrical Connection

The appliance is designed to be
connected to 230 V monophase electricity
supply.
The connection must be carried out in
compliance with the laws and regulations in
force.
Before the appliance is connected:
1) check that the main fuse and the
domestic installation can support the load
(see the rating label);
2) check that the power supply is properly
earthed in compliance with the current rules;
3) check the socket or the double pole
switch used for the electrical connection can
be easily reached with the appliance built in
the forniture unit.
The appliance is supplied with a
connection cable. This has to be provided
with a proper plug, able to support the load
marked on the identification plate. To
connect the plug to the cable, follow the
recommendation given in Fig. 3a. The plug
has to be fitted in a proper socket.
If connecting the appliance directly to
the electric system, it is necessary that you
install a double pole switch between the
appliance and the electricity supply, with a
minimum gap of 3 mm. between the switch
contacts and of a type suitable for the
required load in compliance with the current
rules.
The connection cable has to be placed in
order that, in each part, it cannot reach a
temperature 50°C higher than room
temperature.
The brown coloured phase cable (fitted in
the terminal block contact marked with "L")
must always be connected to the network
phase.
Remplacement of the voltage cable
The connection of the voltage cable to
the appliance's terminal block is of type "Y".
This means that its replacement requires the
specific equipment of a technician. In this
case, only cable type H05V2V2-F T90 must be
used. The cable section must be suitable to
the voltage and the working temperature.
The yellow/green earth wire must be
approximately 2 cm. longer than the phase
wires (Fig. 3-a).
To open the terminal block and
reach the terminals, proceed as
follows:
insert the point of a screwdriver into
the visible protrunding part of the
terminal block;
exert a light pressure and lift (Fig. 3-
b)
Phase
Fig. 3-a
Fig. 3-b
Neutral
Earth
(yellow/green)

Advertisement

Table of Contents
loading

This manual is also suitable for:

65857 g-m95857 g-m75857 g-m