Before Using For The First Time; Setting/Changing The Time - AEG COMPETENCE B 3100 Operating Instructions Manual

Operating Instructions

Before using for the first time

Setting/Changing the Time

The time display will flash after the electrical supply is connected.
You must then first set the time.
If the time has not been set, the oven cannot be switched on.
Setting the Time
1. Press the M button.
0
2. Set the current time within
5 seconds using the + or - but-
tons.
The time appears in the display.
The oven is now ready for use.
By pressing the + or - button
3
for more than 2 seconds, the min-
utes will start to run forwards or
backwards until the button is
released again. By this means you
can reach the required setting
quicker.
If the appliance has been isolated from the mains, e.g. due to a power
3
failure, the time display will flash again.
In this case reset the time again, as described above.
Changing the Time
If you wish to correct the time, e.g. on the change over from summer to
winter time, repeat the process described under "Setting the Time".
12