Electrolux EKG511106 User Manual page 18

18 electrolux
Burner Normal
power
(kW)
Semi- 1,90
rapid 2,00
1,70
Auxiliary 1,00
1,00
0,85
Oven 3,00
3,00
2,60
Grill 2,00
2,00
1,70
Adjustment of minimum level
The burner is correctly adjusted when the
flame is stable silent and goes out without
any noise.
When changing the type of gas check that
the minimum level is correct. The air admis-
sion is correct when the flame is about 4 mm
in length.
The top burners do not need adjustment of
primary air.
Check that, turning the knob quickly from the
maximum position to the minimum one, the
flame does not go out.
To adjust the minimum level of the burners,
proceed as follows:
1. light the burner;
2. turn the knob on the position of minimum
flame;
3. remove the knob;
4. with a thin screwdriver, adjust the bypass
screw;
CAT:2H3B/P
Eco- Gas Type
nomic
power
(kW)
0,45 Natural gas G 20
0,43 Butan G 30
0,38 Propan G 31
0,35 Natural gas G 20
0,35 Butan G 30
0,31 Propan G 31
1,00 Natural gas G 20
1,00 Butan G 30
0,85 Propan G 31
- Natural gas G 20
- Butan G 30
- Propan G 31
Pres- By-
sure pass
(mbar) (mm)
20 0,32
28-30
30
20 0,30
28-30
30
20 0,46
28-30
30
20 -
28-30
30
Reassemble the parts following the same
procedure backwards.
Finally, check the flame does not go out
when quickly turning the knob from the max-
imum position to the minimum position.
Gas oven burner nozzle
Warning! Before replacing the nozzles
ensure that the gas knobs are in OFF
position and disconnect the appliance
from the electrical supply.
Nozzle replacement
1. Remove the bottom plate of the oven
cavity.
2. Remove the screw 1 on the oven burner.
3. Remove the oven burner by pulling it for-
wards.
4. Replace the nozzle by means of a No 10
socket spanner.
5. Reassemble the burner following the
same procedure in reverse
6. Before fixing of the screw 1, ensure that
the oven burner is pushed correctly to the
back panel.
Nozzle di- (g/h)
ameter
(mm)
0,96 -
0,71 145,43
0,71 121,40
0,70 -
0,50 72,71
0,50 61,70
1,16 -
0,87 218,1
0,87 188,8
0,96 -
0,71 145,4
0,71 123,4