Cleaning The Air Filter Element - Yamaha YBR125 Custom Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
4. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
5. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the engine
oil filler cap.
Recommended engine oil:
See page 8-1.
Oil change quantity:
6
1.00 L (1.06 US qt, 0.88 Imp.qt)
CAUTION:
G
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
1. "CD" specification
2. "ENERGY CONSERVING II"
6. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
ECA11620
mediately turn the engine off and
check for the cause.
7. Turn the engine off, and then
check the oil level and correct it if
necessary.
6-10

Cleaning the air filter element

The air filter element should be cleaned
at the intervals specified in the periodic
1
maintenance and lubrication chart.
Clean the air filter element more fre-
quently if you are riding in unusually
wet or dusty areas.
1. Remove panel B. (See page 6-6.)
2. Remove the air filter case cover by
2
removing the screws.
1
2
1
1. Screw
2. Air filter case cover
3. Remove the air filter element.
EAU37121