Yamaha YZF-R1 Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
To adjust the display brightness
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then, af-
ter five seconds, release the
"SELECT" button.
4. Push the "RESET" button to select
3
the desired display brightness lev-
el.
5. Push the "SELECT" button to con-
firm the selected display bright-
ness level. The control mode
changes to the engine speed indi-
cator light activity function.
To set the engine speed indicator light
activity function
1. Push the "RESET" button to select
one of the following indicator light
activity settings:
a. The indicator light will stay on
when activated. (This setting is se-
lected when the indicator light
stays on.)
b. The indicator light will flash when
activated. (This setting is selected
when the indicator light flashes
four times per second.)
c. The indicator light is deactivated;
in other words, it will not come on
or flash. (This setting is selected
when the indicator light flashes
once every two seconds.)
2. Push the "SELECT" button to con-
firm the selected indicator light ac-
tivity. The control mode changes
to the engine speed indicator light
activation function.
3-9
To set the engine speed indicator light
activation function
NOTE:
_
The indicator light activation function can
be set between 7,000 and 12,000 r/min
in increments of 500 r/min.
_
1. Push the "RESET" button to select
the desired engine speed for acti-
vating the indicator light.
2. Push the "SELECT" button to con-
firm the selected engine speed.
The control mode changes to the
engine speed indicator light deac-
tivation function.