Yamaha YZF-R1 Owner's Manual page 25

The electric tachometer allows the rider
to monitor the engine speed and keep it
within the ideal power range.
When the key is turned to "ON", the ta-
chometer needle sweeps once across
the r/min range and then returns to zero
r/min in order to test the electrical cir-
cuit.
NOTICE
Do not operate the engine in the ta-
chometer red zone.
Red zone: 13750 r/min and above
Clock and stopwatch modes
1. Clock/stopwatch
INSTRUMENT AND CONTROL FUNCTIONS
To set the clock
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flashing,
push the "RESET" button to set the
hours.
3. Push the "SELECT" button, and
ECA10031 the minute digits start flashing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.
To display the stopwatch
To change the display to the stopwatch
mode, push the "SELECT" button and
"RESET" button together. To change
the display back to the clock mode,
push the "SELECT" button and "RE-
SET" button together; however, this is
not possible when the stopwatch is
counting.
1
Standard measurement
1. Push the "RESET" button to start
the stopwatch.
2. Push the "SELECT" button to stop
the stopwatch.
3. Push the "SELECT" button again
Split time measurement
1. Push the "RESET" button to start
2. Push the start switch "
3. Push the start switch "
3-10
to reset the stopwatch.
the stopwatch.
" or "RE-
SET" button to measure split
times. Split times are displayed on
the odometer display for five sec-
onds.
" or "RE-
SET" button to display the final
split time or push the "SELECT"
button to stop the stopwatch and
display the total elapsed time.
3