What To Do If - Electrolux EKC601503 User Manual

5. gently pull the oven door off its site
6. place it on a steady plan.
Important! Clean the oven door glass with
warm soapy water and a soft cloth only.
Never use harsh abrasive.
Once the cleaning is carried out, refit the
oven door, following the procedure in re-
verse.
Warning! Do not clean the oven door
while the glass panels are warm. If this
precaution is not observed the glass
panel may shatter.
If the door glass panel becomes chipped
or has deep scratches, the glass will be
weakened and must be replaced to pre-
vent the possibility of the panel shatter-
ing. Contact your local Service Centre
who will be pleased to advise further.
Models in stainless steel or aluminium
We recommend to clean the oven door using
only a wet sponge and dry it up after cleaning
with a soft cloth.
Never use steel wool, acids or abrasive prod-
ucts as they can damage the oven surface.
Clean the oven control panel following the
same precautions.
The correct operation of the oven is ensured
by a gasket placed round the edge of the
oven cavity.
Periodically check the condition of this gas-
ket. If necessary, clean it without using abra-
sive cleaning products.
If the gasket shows to be damaged, call you
local Service Centre. Do not use the oven
until it has been repaired.
Oven shelves
Warning! Before proceeding ensure the
oven is cool and disconnected from the
electricity supply.

What to do if...

If the appliance is not working correctly, please carry out the following checks, before con-
tacting your local Service Centre.
To clean the oven shelves, soak in warm
soapy water and remove stubborn marks
with a well wetted soap impregnated pad.
Rinse well and dry with a soft cloth.
Oven lamp replacement
Warning! Disconnect the appliance
from the electricity supply.
If the oven bulb needs replacing, it must
comply with the following specifications:
electric power, 15 W /25 W; electric rate, 230
V (50 Hz); resistant to temperatures of 300
C; connection type: E 14. These bulbs are
available from your local Service Force Cen-
tre.
To replace the faulty bulb:
1. Ensure the oven is disconnected from the
electrical supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace it with
the new one.
4. Refit the glass cover.
5. Reconnect to the electrical supply.
electrolux 15
°