Assemble The Detachable Blower For "Blowing - RIDGID WD12800 Owner's Manual

SP6728-1 16 Gallon
Operation (continued)
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
!
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the Vac/Blower for
extended time or in a noisy area.
1. Familiarize yourself with the detachable
blower portion of your Wet/Dry Vac.
2. Remove the detachable blower of your
Vac by pressing down on the power
head latch under the handle of the
detachable blower. (This power head
latch holds the detachable blower to
the lid assembly.)
Male-Male
Adapter
3. Lift the detachable blower up by raising
the handle upward and pulling the unit
away from its nested position on the lid.
3/19/10 10:58 AM
Goggles
Dust Mask
Blowing Port
Extension
Wand
Blower Nozzle or
Car Nozzle
Page 11
Assemble the Detachable
Blower for "Blowing"
This may be assembled three ways:
1. Insert the small end of one of the
extension wands into the blowing port of
the detachable blower. Insert the male-
male adapter into the extension wand
and install the blower nozzle or car
nozzle onto the male-male adapter.
- OR -
2. Insert the male-male adapter into the
blowing port of the detachable blower.
Connect the large end of the extension
wand to the male-male adapter. Connect
the blower nozzle or car nozzle to the
extension wand. If the additional reach is
not needed, simply omit the wand, and
connect the blower nozzle or car nozzle
to the male-male adapter.
3. The Wet/Dry Vac may also be used for
blowing using the seven foot hose
supplied with the Wet/Dry Vac. Install
the male-male adapter in the blowing
port of the Wet/Dry Vac. The male-
male adapter will insert into the inside
of the push button end of the Vac
hose. Assemble the hose to the male-
male adapter and connect the blower
nozzle or car nozzle to the opposite
end of the hose. The unit is ready for
blowing applications.
4. Turn the blower "ON" by toggling the
switch in the handle of the blower to
the "ON" position.
11
Blowing Port
Blower
Nozzle or
Car Nozzle
Male-Male
Adapter
Blower
Nozzle or
Car Nozzle
Male-Male
Adapter