2.
Slide the door off the pin (G). Unscrew
the pin (G) and install it on the opposite
side.
3.
Unscrew the pivot pin (Z) of the hinge
(E) and the rear screw (Y) with a spanner
of 10 mm and remove the closing device
(M). Take from the accessory bag the
lower closing device left and install it on
the opposite side of the same hinge by
screwing again the rear screw.
4.
Unscrew the upper closing device (N)
from the bottom of the door. Take from
the accessory bag the upper closing de-
vice left and install it on the opposite
side of the bottom of the door by screw-
ing again the screw.
5.
Install the door.
6.
Install the bottom hinge (E) on the opposite side, using the three screws previously
removed inserting the hinge gasket (X).
7.
Remove the blanking cover (F) from the ventilation grille (D) by pushing it in the
direction of the arrow and install it on the opposite side.
8.
Install the ventilation grille (D), clipping it into place.
9.
Unscrew the handle. Remove the plug
with a punch. Install the handle and the
plug on opposite side. Take from the ac-
cessory bag the two plugs and cover the
holes left open after having removed the
handle.
10. Make sure that the front board of the
door is parallel to the front board of the
top.
11. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the cabinet.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the gasket.
Environmental concerns
The symbol
treated as household waste. Instead it should be taken to the appropriate collection point
for the recycling of electrical and electronic equipment. By ensuring this product is disposed
on the product or on its packaging indicates that this product may not be
Environmental concerns
15
G