Rehingeing The Door - AEG ÖKO - SANTO Operating Instructions Manual

Your appliance needs air
For safety reasons, minimum ven-
tilationmust be as shown Fig.
Attention: keep ventilation ope-
nings clear of obstruction;
Rear spacers
In the bag with the documentation,
there are two spacers which must
be fitted.
Fit the spacers into the holes,
taking care to ensure that the
arrow (A) is positioned as shown in
Fig.. Then turn them through 45¡
(arrow (A) vertical) until they lock
into place.

Rehingeing the door

The side at which the door opens can be changed from the right side
(factory adjustment) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the
appliance may not be connected to the mains. Remove plug from the
mains beforehand.
Procced as follow:
1. Remove the lower hinge (3), the
pin(1) and the support foot (2).
2. Remove the left support foot and fit
it on the opposite side.
3. Slide the bottom door off the centre
hinge (H).
4. Remove the centre hinge and slide
the top door off pin (D); unscrew
pin (D) and refit it on the opposite
28
NP005
A
45°
PR60
D590
D