Water outlet hose connection
The end of the drain hose can be connected in the following ways:
1 1 . . To the sink outlet spigot, securing it to the underside of the work surface.
This will prevent waste water from the sink running into the machine.
2 2 . . To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.
The waste connection must be at a height of between 30 cm (minimum) and
100 cm (maximum) from the bottom of the dishwasher.
The drain hose can face either to the right or left of the dishwasher
Ensure the hose is not bent or squashed as this could prevent or slow down the
discharge of water.
The sink plug must not be in place when the machine is draining as this could
cause the water to syphon back into the machine.
If you use a drain hose extension it must be no longer than 2 metres and its
internal diameter must be no smaller than the diameter of the hose provided.
Likewise the internal diameter of the
couplings used for connections to the
waste outlet must be no smaller than the
diameter of the hose provided.
When connecting the drain hose to an
under sink trap spigot, t t h h e e e e n n t t i i r r e e p p l l a a s s t t i i c c
m m e e m m b b r r a a n n e e ( ( A A ) ) m m u u s s t t b b e e r r e e m m o o v v e e d d . Failure to
remove all the membrane will result in food
particles building up over time eventually
blocking the dishwasher drain hose spigot.
Our appliances are supplied with a security device to protect against the return
of dirty water back into the machine.
If the spigot of your sink has a "no return valve" incorporated this can prevent
the correct draining of your dishwasher. We therefore advise you to remove it.