Installation - Electrolux FAVORIT 40760 User Manual

Installation

37
Installation
Any electrical and/or plumbing work required to install this appliance should be
carried out by a qualified electrician and/or plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Fixing under a counter (kitchen worktop or sink)
By removing the machine's worktop, you
can install it under a close fitting sink unit
or a pre-existing top, providing the
dimensions of the recess correspond to
those shown in the picture.
Remove the machine's worktop by
unscrewing the two rear retaining screws,
pull the worktop from the back of the
machine and slide out the front slots, lifting
the worktop.
Insert the machine after adjusting the
levelling with the adjustable feet. When
inserting the machine, ensure that the
water inlet and drain hoses are not kinked
or squashed.
During all operations that involve
accessibility to internal components the
dishwasher has to be unplugged.
Be sure that once the appliance has been installed, it is easily accessible for the
service engineer in the event that a repair is required.
If the dishwasher is later used as a free-standing appliance, the original
worktop must be re-mounted.
The plinth on free-standing appliances is not adjustable.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on either side
of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until
the machine is perfectly level.