Honeywell Dolphin 6500 User Manual page 29

Main Battery Pack
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in
damage not covered by the warranty.
The Dolphin 6500 has a Li-Ion 3.7V/3300 mAh/12.2 Wh battery pack.
The Li-Ion battery pack is the primary power source for the Dolphin terminal as well as the internal backup
battery.
Changing the Main Battery Pack
Before installing a battery pack, press the Power button on the 28-key Dolphin 6500 or press the Blue
then Z (Power) keys on the 52-key Dolphin 6500 to put the terminal in
so that operations are suspended before removing the main power source. The Dolphin 6500 is shipped
with the battery separate from the unit. You will need to loosen the hand strap, remove the battery door,
insert the battery, and replace the battery door. Refer to the instructions included in
Battery section (page 2-1).
Note: The battery door must be installed prior to booting the unit.
Charging Options
When the battery is installed in the terminal, you can use any of the peripherals listed below to charge the
battery.
• Dolphin HomeBase/eBase Device
• Dolphin Comm/Charge Cable;
6500 (see page 6-2) You may charge the device using the USB connection if you do not have a wall
adapter. There are two options that allow either 100mA or 500mA of current over the USB connection.
Access the option by selecting Start > Settings > Control Panel > Power > USB Charging.
To fully charge the Li-Ion battery before installing it in the terminal, use the
• Dolphin QuadCharger Device
the back of either the Dolphin HomeBase or Dolphin eBase.
Charging Time
The 3300mAh battery pack charges to full capacity in an average of 5 1/2 hours for a fully depleted
battery. It takes less time if the battery has some charge.
(see page 8-1)
Connecting the USB Charging/Communication Cable for the Dolphin
(see page 9-1) or insert the battery in the spare battery charging well in
Suspend Mode (see page 3-16)
Installing the Main
Cover Locks
Main Battery
3 - 13