Table of Contents
Advertisement
Moving the machine
If you have to move the machine (moving house etc....):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge hoses.
4. Pull the machine out together with the hoses.
Avoid over tilting the machine during transportation.
What to do if ...
The dishwasher will not start or stops during operation. Certain problems are due
to the lack of simple maintenance or oversights, which can be solved with the help
of the indications described in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the following suggested corrective actions.
Fault code and malfunction
• continuous flashing of the START/RESET in-
dicator light
• 1 flash of the end of programme indicator
light
The dishwasher does not fill with water
• continuous flashing of the START/RESET in-
dicator light
• 2 flashes of the end of programme indica-
tor light
The dishwasher will not drain
• continuous flashing of the START/RESET in-
dicator light
• 3 flashes of the end of programme indica-
tor light
What to do if ...
Possible cause and solution
• The water tap is blocked or furred with lime-
scale
Clean the water tap
• The water tap is turned off
Turn the water tap on
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked
Clean the filter in the threaded hose
• The water inlet hose has not been correctly
laid or it is bent or squashed
Check the water drain hose connection
• The sink spigot is blocked
Clean out the sink spigot
• The water drain hose has not been correctly
laid or it is bent or squashed
Check the water drain hose connection
• Anti-flood device is activated
Close the water tap and contact your local Serv-
ice Force Center.
27
Advertisement
Table of Contents
