Checking And Lubricating The Brake And Shift Pedals - Yamaha Wild Star XV1600A Owner's Manual

3. To tighten the drive belt, turn the
adjusting bolt on each side of the
swingarm in direction a. To loos-
en the drive belt, turn the adjusting
bolt on each side of the swingarm
in direction b, and then push the
rear wheel forward.
NOTE:
@
Turn each adjusting bolt the same
amount for proper wheel alignment.
@
4. Tighten the locknuts.
CAUTION:
@
Improper drive belt slack will over-
load the engine. Keep the drive belt
slack within the specified range.
@
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Drive belt slack adjusting bolt ( 2)
2. Drive belt puller locknut ( 2)
3. Wheel axle
5. Tighten the axle nut and the brake
ECA00025
caliper bracket bolt to the specified
torques.
Tightening torques:
Axle nut:
150 Nm (15 m·kg)
Brake caliper bracket bolt:
48 Nm (4.8 m·kg)
Checking and lubricating the
brake and shift pedals
The operation of the brake and shift
pedals should be checked before each
ride, and the pedal pivots should be lu-
bricated if necessary.
6-28
Recommended lubricant:
Lithium-soap-based grease
(all-purpose grease)
EAU03370
6