Electrical Connection - AEG A92970GNM0 User Manual

Aeg freezer
Table of Contents

Advertisement

7.2 Location

7.3 Electrical Connection

CAUTION!
Any electrical work required to
install this appliance should be
carried out by a qualified electri-
cian or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any li-
ability should these safety meas-
ures not be observed.
1
5
The wires in the mains lead are
coloured in accordance with the
following code:
To ensure best performance, if the appli-
50 mm
ance is positioned below an overhang-
ing wall unit, the minimum distance be-
tween the top of the cabinet and the
wall unit must be at least 40 mm. Ideally,
however, the appliance should not be
positioned below overhanging wall units.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top
cupboard must be at least 50 mm
deep.
1
Green and Yellow:
3
Brown:
5
Blue:
As the colours of the wires in the mains
lead of this appliance may not corre-
spond with the coloured markings iden-
tifying the terminals in your plug, pro-
ceed as follows:
1.
Connect the wire coloured green
and yellow to the terminal marked
either with the letter "E" or by the
earth symbol
2
and yellow.
2.
Connect the wire coloured blue to
the terminal either marked with the
letter "N" or coloured black.
3.
Connect the wire coloured brown to
the terminal either marked with the
"L" or coloured red.
4.
Check that no cut, or stray strands of
wire is present and the cord clamp
5.
Make sure the electricity supply volt-
age is the same as that indicated on
the appliance rating plate.
3
6.
Switch on the appliance.
The appliance is supplied with a 13 amp
4
plug fitted
change the fuse in the plug supplied, a
13 amp ASTA approved (BS 1362) fuse
must be used.
or coloured green
4
is secure over the outer sheath.
2
. In the event of having to
ENGLISH
15
Earth
Live
Neutral

Advertisement

Table of Contents
loading

Table of Contents