Replacing The Tail/Brake Light Bulb; Supporting The Motorcycle - Yamaha TW125 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
2
3
1. Screw ( 2)
4
Replacing the tail/brake light
5
bulb
1. Remove the tail/brake light lens
6
by removing the screws.
7
8
9
1. Bulb
EAU01623
2. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
cC
Do not overtighten the screws,
otherwise the lens may break.

Supporting the motorcycle

Since this model is not equipped with
1
a centerstand, follow these precau-
tions when removing the front and
rear wheel or performing other main-
tenance requiring the motorcycle to
stand upright. Check that the motor-
cycle is in a stable and level position
before starting any maintenance. A
strong wooden box can be placed
under the engine for added stability.
To service the front wheel
EC000108
6-37
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing
a jack under the frame in front of
the rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
EAU01579