Yamaha FZ1-N Owner's Manual page 89

3
2
1
1. Front wheel axle pinch bolt
2. Wheel axle
3. Brake caliper bolt
2. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
3. Remove the brake hose holder on
each side by removing the bolt and
nut.
4. Remove the brake caliper on each
side by removing
NOTICE: Do not apply the brake
after the brake calipers have
been removed, otherwise the
brake pads will be forced shut.
[ECA11051]
PERIODIC MAINTENANCE AND ADJUSTMENT
1. Brake hose holder
2. Bolt and nut
3. Brake caliper bolt
4. Brake caliper
5. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle.
the bolts.
3. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
4. Install the brake calipers by install-
ing the bolts.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
5. Install the brake hose holders by
6. Tighten the brake caliper bolts to
7. Tighten the wheel axle, and then
EAU39402
8. Push down hard on the handlebar
6-39
installing the bolt and nut.
the specified torque.
Tightening torque:
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
the wheel axle pinch bolt to their
specified torque.
Tightening torques:
Wheel axle:
72 Nm (7.2 m·kgf, 52 ft·lbf)
Front wheel axle pinch bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
several times to check for proper
fork operation.
6