What To Do If - Electrolux FM 4513 K-AN User Manual

18

What to do if ...

What to do if ...
The cooking zones will not
switch on or are not function-
ing
The residual heat indicator is
not displaying anything
The automatic warm-up func-
tion is not switching on
e
and number are displayed
If you are unable to remedy the problem by following the above sugges-
tions, please contact your dealer or the Customer Care Department.
Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
If the appliance has been wrongly operated, the visit from the customer service
technician or dealer may not take place free of charge, even during the warranty
period.
Problem
More than 10 seconds have
passed since the appliance was
switched on
The child safety device is
switched on l
Several sensor fields were
touched at the same time
The sensor fields are partly
covered by a damp cloth or
with liquid
Automatic switch off has been
triggered
STOP+GO is activated
The cooking zone was only on
for a short time and is there-
fore not hot
The highest heat setting is set
Ç
Electronics fault
Possible cause
u
Remedy
Switch the appliance on again.
Deactivate the child safety
device (See the section "Child
safety device")
Only touch one sensor field
Remove the cloth or the liquid.
Switch the appliance on again.
Switch the appliance on again
Switching off STOP+GO
If the cooking zone is sup-
posed to be hot, call the Cus-
tomer Service Department.
The highest heat setting has
the same power as the auto-
matic warm-up function
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of
the house's wiring system)
If after switching on again,
is displayed again, call the cus-
tomer service department
e