RCA J12H770 User Manual page 11

Installing TV on Suspension Arm - J12H770-DV3 / J12H770-DV4
The J12H770 is designed to attach to a wall mounted suspension arm capable of supporting a television
weighting 14 pounds. The single coaxial cable on top of the unit is used to supply either low voltage DC
power (24 volts) and the RF signal to the television.
Male RF Cable
Male 3.5mm Cable
(Y, Pb, Pr)
Male DC 5V Jack
Male 3.5mm Cable
(Audio)
DANGER: ARM RECOIL HAZARD The safety brake pin must remain in the SAFETY BRAKE PIN HOLE
whenever the television set is removed from the arm or when the arm is removed from the wall
bracket to prevent the arm from springing open.
CAUTION: DO NOT REMOVE the Beige silicon cover from the swivel assembly. This swivel assembly is factory
preassembled and adjusted. There is no need to remove the cover.
IMPORTANT: These instructions detail installing the TV onto the FC-80 suspension arm. This arm is configured
specifically for this television. The J12H770 may be installed on other FC Series arms.
Chapter 1
Chapter 1: Connections and Setup
Female 3.5mm Stereo Cable
(RS232C)
11