Power - Honeywell Dolphin 7600 User Manual

Power

The terminal requires 5 volts DC input for communication and battery charging; the power adapter on the
power cable converts the voltage from the power source to 5 volts DC. Only power adapter cables from
Hand Held Products convert the voltage appropriately.
The same power cable that ships with each terminal can be used to power the base. This cable contains
a plug adapter for each geography (US, UK, EU, etc.).
1. Attach the appropriate plug adapter to the power adapter.
2. Plug the power cable into the power source.
3. Plug the connector into the DC power jack on the back panel. The base is now powered.
When a terminal is properly seated in the terminal well, the base powers the terminal, charges the
terminal's main battery pack, and launches ActiveSync (see
Honeywell recommends that you leave the base connected to its power source at all times, so that it is
always ready to use.
11 - 4
1
Plug Adapter
Power Adapter
Power Cable
ActiveSync Communication on page 3-18).