Table of Contents
Advertisement
USER'S MANUAL
USER'S MANUAL
9.
A final dialog box will appear, (similar to the message below) advising that the software
was successfully installed. Click "Restart."
Congratulations! Driver installation is now complete. You may now connect the reader to
your computer after restarting. Proceed to the next page for instructions on connecting
your Dazzle card Reader.
INSTALLATION NOTE: If you attempt to attach the reader's cable to the USB port of
your Macintosh or hub prior to installing the drivers, you may receive a message similar to
the one shown below:
If this occurs, click "Cancel", install the driver software from the Dazzle installation CD-ROM, and
then connect the reader. For more information on attaching USB devices proceed to the section
"Connecting to the USB Port" (page 11) or "Connecting to a USB Hub" (page 12).
10
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DAZZLE and is the answer not in the manual?
Questions and answers