In-Dash CD Changer (sold separately):
P/N 08A06-3E1-300
In-Dash CD changer
6 Washer-screws, 5 x 8 mm
(2 not used)
Washer-screw, 4 x 6 mm
Wire tie
(not used)
Harness clip
Owner's Manual
2 Felt strips (not used)
TOOLS AND SUPPLIES REQUIRED
#2 Phillips screwdriver
Flat-tip screwdriver
Ratchet
10 mm Socket
10 mm Combination wrenches
2 of 6
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
3.
Place the shift lever in the N (Neutral) position.
4.
Remove the center panel (nine clips, and
disconnect the vehicle connectors).
CLIPS (9)
CENTER
PANEL
5.
Remove the pocket (two bolts and the two clips).
CLIPS (2)
BOLT
AII 27341 (0409)
VEHICLE
CONNECTOR
VEHICLE
CONNECTOR
POCKET
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
4219011B
4219021B