YATOUR YT-M06 User Manual page 4

3. Attach the wire harness connector to the back of the stereo to the CD
changer port. Be sure to make a firm connection but do not force it.
4. Once the Yatour is connected to the radio, you will need to test the
operation of the interface before re-assembling the dash. Insert SD
card or USB flash stick, and power on the Head Unit, then press CD (or
Disc / Mode / CDC / SOURCE / AUX) button for once or twice to switch
to playback mode of Digital Music Changer, with the symbol of LED
light being on. Meanwhile, CDC, EX, or CD01 will display on the radio
screen(depending on the car stereo type). Now the Digital Music
Changer will run normally.
5. After successful test, re-assemble the radio, and put wire harness and
module unit box in proper place. Then installation is completed. If you
experience difficulties with the installation, please check our
troubleshooting section of this manual.
Important Note :
1. If there is a BLACK ground wire on the harness, please attach it to any
metal part of the car stereo body; If there is a YELLOW power wire on
the harness, please attach it to the power of the car, which connect to
battery; If there is a RED ACC wire on the harness, please attach it to
the ACC signal of the car. Without attaching those cables to the right
position, this Digital Music Changer will not work!
2. As to some vehicles with existing CD Changer, Parallel Harness or
MP3/CDC Switch Cable will be provided. This allows Digital Music
Changer to hook up with existing CD Changer. Simply connect the
existing CD Changer to the male connector of Digital Music Changer.
3. Regarding Fiat, Renault models, two black wires with metal ends
(male+female) come along with CDC connector. If noise problem
exists when using Digital Music Changer, please hook up the two
grounding wires with each other.
4. As for Audi factory radio of mini ISO 8 pin, its CDC connector is 20-pin
block connector, in order to install Yatour, it requires to cut the 8-pin
part or connect with our special Audi 20-pin adapter cable.
5. As for Clarion protocol radios, such as some BUICK radio and SUZUKI
radio, it requires to totally unplug the wire harness before installation,
in order to power off the electric supply. If not, it would probably cause
—[3]—