This function has already been used for the
playback function of recording, but please
confirm again.
CD
Set the function mark (
~
) display to PLAY
by pushing FUNCTION select key
®.
(Play-
function)
®
Select the track which you want to play from
the tracks with
*
mark on the track
indication display, and push the TRACK key
o
you selected and make the PLAY display
flash.
2
*
I-PLAY-
'" I'
1
4
*1
1
5
*
I-PLAY-
I
16
1
®
The performance will start by pushing the
START/STOP (
~
I. )
key
40.
(There
is no
count meter)
PLA Y display will change from flashing
to constant.
I
L
"JIIf I
I""'LAT
1 3*1
PLAY
1
4
*1
1 5*1
PLAY
I~
@ Push the START/STOP (
~
I. ) key to stop
during the performance.
Push this key
again in order to start the performance
where it stopped. If you want to return to
the beginning of the music, push RESET
(
~
) key
0.
@ If you want to cancel the PLAY of the
selected track, push this TRACK key
0
when the performance is stopped.
"*
The bar will be reset to 0 with this
cancellation.
When the sound does not stop
----~
When the sound does not stop even though
you stopped your performance (it happens
when there is a tie over two bars with more
than 17 sounds), push the top and the
bottom of the FUNCTION select key at the
same time.
The effect such as Bender, Modulation,
After Touch, Portament will still be on
when you stop your performance at a part
with those effects. When this happens, push
the top and the bottom of the FUNCTION
select key to put them back to their original
condition.
After you performed music with a fade-out,
the volume will stop at 0 so push the top and
the bottom of the FUNCTION select key at
the same time, or select the play track again
in order to return them to their original
condition.
*
If you set the measure-memory on a certain
bar, you can stop the performance and the
fast forward at the end of that bar. If the
repeat is on, the performance will stop at
that bar and go back to the beginning and
play it again.
CD
Set the function mark (
~
) display to
PLAY by pushing FUNCTION select key
8.
(Play-function)
®
Push START/STOP (
~
/ •
) key
40
or FF
(
~)
key 6l to indicate the bar which you
want to set the measure-memory on the
MEASURE indication.
®
By Pushing the MEASURE MEMORY key
e,
you can set the measure-memory.
~
will be indicated on the display for
MEASURE indication.
j
=
MEASURE
Ii!iJ
- 20-