Microsoft Windows Nt; Windows Nt 4.0; Installation Procedures - Asus AGP-V3400TNT/8MB User Manual

IV. Microsoft Windows NT

Windows NT 4.0

WARNING! Before installing the ASUS AGP-V3400TNT series display driver
in Windows NT 4.0, make sure that you have installed Windows NT 4.0 Ser-
vice Pack3 (available on the Internet at
bldqpage.idc? ProductPage=q_servpk
not be able to start up!
NOTE: For all the AGP features to be available you must be using Windows NT 5.0.

Installation Procedures

1. Start Windows NT, switch display properties to VGA mode (16 colors, 640 x 480
pixels), then restart your computer to make the change.
2. After your computer restarts, right-click the desktop and click Properties.
3. Click the Settings tab.
4. Select Change Display Type.
5. Select Adapter Type and click Change.
6. Click Have Disk.
7. Insert the ASUS AGP-V3400TNT Series Installation CD disc.
8. Type D:\NT40 (assuming your CD-ROM disc drive is in drive D) or click Browse
to select the path of the display driver for Windows NT. Click OK.
9. You will see a list of ASUS AGP-V3400TNT Series drivers. Select your driver
and then click OK.
10. Windows NT will once again prompt for confirmation. All appropriate files are
then copied to the hard disk. When all files are copied, go back to the Display
Properties box by clicking Close. Click Apply.
11. The System Settings Change dialog box is displayed. Click Yes to restart Windows.
12. Windows NT will restart with the default settings. The Display applet will ap-
pear to allow for mode selection.
http://www.microsoft.com/isapi/support/
). Otherwise, the system will hang and will
ASUS AGP-V3400TNT Series 33