Table of Contents
Advertisement
ASMC Help Menu options
Options
-flash -load filename
-sdr -save filename
-sdr -load filename
-kcs[smic/bt/pci_smic] NetFn command data....
-bmc_ip [ip_addr]
(e.g., bmc_ip 10.10.10.20)
--pet_ip_mac [ip_addr] [mac_addr]
(e.g., pet_ip_mac 10.10.10.20 010203040506)
-adm_name
-user_name
-adm_password
-user_password
-init_asmb
-sol_baud [baud rate]
(e.g., sol_baud 57600)
-bmc_info
2.5.1
Configuring the LAN controller
Before you can establish connection to the ASMB3-SOL board, you must configure
the LAN port for server management used by the remote server to connect to the
local/central server.
To configure the LAN port of the remote server:
1.
On the prompt, type asmc -init_asmb, then press <Enter>. The screen
displays the auto-detected information including the system/motherboard
name, and the IPMI2.0 interface. The screen also shows the status of the
ASMB3-SOL.
c:\dos>asmc -init_asmb
Detect System
Detect Motherboard
Detect KCS Interface
Initial BMC O.K.
2.
Shut down the remote server, then disconnect the power plug from the
electrical socket to initialize the ASMB3-SOL.
3.
Restart the remote server from the support CD.
4.
Run the ASMC utility from the support CD following the instructions in the
previous section.
ASUS ASMB3-SOL
new_name_string
new_name_string
new_adm_password
new_user_password
-> DSBF-D/SAS
-> (DSBF-D/SAS)
Description
Update the ASMB3-SOL firmware
Save the SDR data to file
Update the SDR data from file
Send IPMI command
Write the BMC IP address
Write the PET destination IP and MAC
addresses
Change the administration name
Change the user name
Change the administration password
Change the user password
Initialize ASMB3-SOL
Set the communication Baud rate
Displays the BMC and PET IP and
MAC addresses
2-13
Advertisement
Table of Contents
