LG ARNH963K2A2 Installation Manual page 45

Hydro kit medium temperature (k2) btu/h 107,500; hydro kit high temperature (k3) btu/h 86,000
Hide thumbs Also See for ARNH963K2A2:
Table of Contents

Advertisement

7. If using the top right edge entry point, use needle nose pliers to
carefully break-off the tab as shown in Figure 40.
8. Route the cable through the appropriate entry point. Refer back
to Step 3.
9. If a back entry is selected, route the female plug-end of the Hydro Kit
Wall Mounted Controller cable already located in the handy box or
protruding from the wall surface through the large hole on the back
side of the subbase. Attach the subbase to the wall or handy box
using the appropriate screws or fasteners (Figure 38).
10. Level the controller and tighten screws on the subbase being
careful not to overtighten which may bend, stress, cause damage
Attach from Top
Remote
Sub-base
Controller
Body
Figure 42: Attaching Controller to Sub-base and to Wall
Hydro Kit Controller
Buttons
Figure 43: Comparison Hydro Kit and Multi V 7-Day Programmable
Controller Buttons
Figure 41: Hydro Kit Unit Controller Communications Cable Termination Detail
Controller Attached to
Subbase
Multi V 7-Day Programmable Controller
Buttons
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
to the PCB board.
11. Plug the male connector of the communications cable whip
attached to the subbase to the socket of the already roughed-in
communications cable (Figure 41).
12. Attach the controller body to the subbase. First insert the top
edge and lastly the bottom edge. Gently push on the frame of the
controller body along the bottom edge until you hear it snap into
place. Gently pull along the bottom edge to verify it is properly
seated (Figure 42).
Be sure to always have powered off before installation of accessories.
Never operate Hydro Kit outside of the operational parameters as out-
lined in this manual and the product specifications.
Never touch wiring or install accessories with wet hands.
• Do not install cable above 164 ft. This can cause communication
errors.
The Multi V 7-Day Programmable zone controller looks very similar to
the Hydro Kit unit controller. Before proceeding with installation verify that
you have to correct model controller in your possession. You can tell the
two controllers apart by the buttons on the panel. See Figure 43 for the
individual controller panels.
fINIsH uP
Accessory Installation
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Arnh763k3b2

Table of Contents