Building In - Electrolux EHG30835X Instruction Book

Building In

Dimensions are given in millimeters
This hob can be inserted in a built-in kitchen unit whose
depth is between 550 and 600 mm. The hob dimensions
are shown in figure 9.
The edge of the cut out must have a minimum distance
from the rear wall of 55 mm.
If there are side walls, or sides of the furniture unit near
the hob, the cut out edges must have a minimum
distance of 100 mm.
TC = Triple Crown burner
Fitting the hob to the worktop
The hob can be installed in a kitchen unit with an opening
for insertion whose dimensions are shown in Fig. 11. To
install the hob, proceed as follows:
1) Place the seals supplied with the hob all around the
edge of the cut out, taking care that the sealings
meet without overlapping.
2) Place the hob in the cut out, taking care that it is
centred.
3) Fix the hob with the relevant screws (Fig. 10). The
traction of the screws is able to trace the sealing, any
excess of which can be easily removed.
The edge of the hob forms a double labyrinth seal which
provides a total guarantee against infiltration of liquids.
If several 30 cm hob are to be installed side by
side into the same cut out, an assembly kit
including a support side bracket and
supplementary sealings is available at our After
Sales Centres. The relevant installation instructions
are supplied within the kit package.
TC
a) Sealing gasket
Fig. 9
a
Fig. 10
65