Table of Contents
Advertisement
3.
The utility immediately starts rebuilding after the disk is selected. The status
of the degraded RAID volume is changed to "Rebuild".
Intel(R) Matrix Storage Manager option ROM v8.5.0.1030 ICH10R/DO wRAID5
RAID Volumes:
ID
0
Physical Disks:
Port Drive Model
1
2
Volumes with "Rebuild" status will be rebuilt within the operating system.
[↑↓]-Select
4.
Exit Intel Matrix Storage Manager and reboot the system.
5.
Select Start > Programs > Intel Matrix Storage > Intel Matrix Storage
Console or click the Intel Matrix Storage Manager tray icon to load the Intel
Matrix Stroage Manager utility.
6.
From the View menu, select Advanced Mode to display the details of the
Intel Matrix Storage Console.
7.
From the Volumes view option, select RAID volume to view the rebuilding
status. When finished, the status is changed to "Normal".
Rebuilding the RAID with a new hard disk
If any of the SATA hard disk drives included in the RAID array failed, the system
displays the status of the RAID volume as "Degraded" during POST. You may
replace the disk drive and rebuild the RAID array.
To rebuild the RAID with a new hard disk:
1.
Remove the failed SATA hard disk and install a new SATA hard disk of the
same specification into the same SATA Port.
Select a destination disk with the same size as the original hard disk.
2.
Reboot the system and then follow the steps in section Rebuilding the RAID
with other non-RAID disk on page 6-31.
6-32
Copyright(C) 2003-08 Intel Corporation.
1. Create RAID Volume
2. Delete RAID Volume
[
DISK/VOLUME INFORMATION
Name
Level
Volume0
RAID1(Mirror)
Serial #
ST3160812AS
9LS0F4HL
ST3160812AS
3LS0JYL8
All Rights Reserved.
[
MAIN MENU
]
3. Reset Disks to Non-RAID
4. Recovery Volume Options
5. Exit
]
Strip
Size
N/A
149.0GB
Size
149.0GB
149.0GB
[ESC]-Exit
[ENTER]-Select Menu
*
= Data is Encrypted
Status
Bootable
Rebuild
Yes
Type/Status(Vol ID)
Member Disk(0)
Member Disk(0)
Chapter 6: RAID configuration
Advertisement
Table of Contents
