Summary of Contents for ABC Office Ideal Cutter 4810
Page 1
“When You Need More Than Staples.” Toll Free: 800-658-8788 Fax: 801-927-3037 info@abcoffice.com IDEAL CUTTERS Model 4810 (18-3/4”) Model 4810-11 (18-3/4”) Model 5210 (20-1/2”)
Safety Rules Ensure that at no time more than one person is working at the machine. Leave the key for the safety lock with the person responsible for the cutting machine. Power operated cutting machines must be operated only by trained and reliable personnel. Part of the training is to become familiar with the operating instructions.
The entire machine is dispatched in one package, but the stand (#7) and the hand wheel (#19) for the paper clamp have been dismounted from the machine. The tool box contains: a set of tools for service and maintenance, the mounting hardware for the stand, the back gauge crank (#3) with a mounting screw, two keys for the safety lock.
Page 4
Turn main switch (#11) to position “|” (on), in order to begin operation. The main switch can be sued as an EMERGENCY SWITCH, which stops the machine immediately. Safety lock with key (#6) The key can be removed to prevent unauthorized use. To activate the machine, turn key 45º to the right.
Turn to the right: back gauge moves towards the knife. Turn to the left: back gauge moves away from the knife. For precise setting of the measurement always move the back gauge from the back towards the knife. Measuring scale Under the viewing window (#14) the measurement scale rotates in accordance with the back gauge movement.
Page 6
The knife change must be executed by one person only. The cutting edge of the knife is extremely sharp. In order to avoid injuries, the knife has to be handled with the utmost care. Transportation of knife is only permitted in specially designed wooden cases, which are supplied with every spare knife ordered from your local distributor.
Page 7
19. Make a test cut with a paper pile using the full cutting height. If necessary do a final adjustment with the cutting depth adjustment screw (#4). 20. IMPORTANT – The clamp bar must be adjusted in a way that the cutting edge of the knife in its home position is covered by the clamp bar.
The guide grooves and all other moving parts of the clamp assembly. The knife carrier guide channels (left and right). They are located between the knife guide plates. All moving parts of the knife drive system. To reach these parts, the lower machine cover (#9) and / or the front table (#13) must be removed.