Inventory - Grizzly G0745 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
box 1 (figures 8–9)
A. 3-Jaw Chuck 2" (pre-installed) ................... 1
b. tool post (pre-installed) ............................ 1
C. tailstock (pre-installed) .............................. 1
D. handwheel handles ................................... 3
E. Chuck guard .............................................. 1
f.
spindle Key 5mm ....................................... 1
G. Chuck Keys 5mm ....................................... 2
H. Wrench 5.5 x 7mm open-Ends .................. 1
I.
phillips head screwdriver #1...................... 1
J. hex Wrenches 3, 4, 5mm .....................1 Ea.
K. Center ......................................................... 1
L. replacement Fuse 2a ................................ 1
-14-
figure 8. lathe as shipped, with pre-installed
Qty
J
i
figure 9. loose inventory items.
a
B
inventory items shown.
E
d
K
l
h
Model G0745 (Mfg. Since 11/13)
C
F
g