Pioneer ANH-P9R Operation Manual page 18

MAN-ANH-P9R-GB.fm Page 18 Tuesday, June 4, 2002 1:39 PM
Using the rotary stick, select "ROUTE SETTINGS" in the route menu and press to
confirm.
If selected, the program calculates the
shortest possible journey time.
If selected, the program calculates the
shortest possible distance.
The setting "SHORT ROUTE" is often recommended for larger cities or metropolis.
Dynamic route guidance is used to calculate the route, taking current traffic
announcements into account.
If dynamic route guidance has been activated, the routes are calculated using the "fast
route" setting.
Further information under "Dynamic navigation with TMC" on page 22.
Provides options for avoiding motorways, ferries or toll roads.
Selection can be made by turning the
right rotary control, and settings can be
changed by pressing the
button.
Press the control for more than 2 seconds to accept all settings and quit the menu.
Routes without motorways can only be calculated for short distances (up to 200 km).
Ä
It is not absolutely necessary to store a destination in the destination memory for route
guidance. It saves repeated manual entry, if the destination is required at a later date.
Select "SAVE DESTINATION" in the route menu and press the
confirm.
Any name of your choice consisting of
up to 14 characters can be entered for
the specified destination and then
automatically stored in the destination
memory after pressing the
button for more than 2 seconds. See
"Destination memory" on page 25.

To store, the small tick can also be selected and the rotary stick briefly pressed.
If you do not wish to enter a name of your choice, press and hold the
for more than 2 seconds to store the address as previously entered in the destination
memory.
The last destination entered can be filled at any position by turning the rotary stick. The
memory position is confirmed by briefly pressing the
A total of 50 destinations can be stored.
For final storage in the destination
memory, either route guidance must be
started or the program must be switched
to new destination entry by selection of
"NEW DESTINATION".
button to
button
button.