Table of Contents
Advertisement
Installing the cabinet
To obtain the best performance from the cabinet,
ensure :
·
the cabinet is placed in a dry, cool place and
is not exposed to direct sunlight.
·
the cabinet is not placed close to a source of
heat, e.g. a cooker or dishwasher.
·
the cabinet is level. The cabinet should not lean
against any wall. If necessary adjust the
feet using the adjustment spanner supplied.
·
there is good air circulation around the cabinet
and that the air channels below and behind
the cabinet are not blocked. The ventilation
space above the cabinet must be at least 4 cm.
The ventilation space can either be
a) directly above the cabinet, or
b) behind and above the top cupboard. In this case,
the space behind the cupboard must be at least
50 mm deep.
Cabinet is placed at a location whose ambient
temperature corresponds to the climate
classification*, for which the appliance is designed.
* See on the rating plate on the inside of the
appliance.
The following table shows which ambient
temperature is correct for each climate classification.
Climate
for an ambient temperature of
classification
SN
N
ST
T
If the cabinet is placed in a corner and the side with
the hinges facing the wall, the distance between the
wall and the cabinet must be at least 10 mm to allow
the door to open enough so that the baskets can be
removed.
The power plug must be accessible after installation
of the cabinet.
When two appliances are placed beside each other,
the distances enclosed in the plastic wrapping should
be glued between the appliances. As shown in the
illustration.
+10°C to +32°C
+16°C to +32°C
+18°C to +38°C
+18°C to +43°C
a)
34
b)
50mm
Electrolux 818 19 37-01/5
Advertisement
Table of Contents
