Use Of Dishwasher Salt - Electrolux ESF 66060 User Manual

Water hardness
mg/l
70 - 189 70 - 189
< 70
1) No use of salt required.
You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at
position 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
4. Install the lower basket.
5. Close the door.
Electronic adjustment
The dishwasher is factory set at
level 5.

USE OF DISHWASHER SALT

Caution! Only use dishwasher salt.
Types of salt that are not suitable for
dishwashers cause damage to the
water softener.
Caution! Grains of salt and salty water
on the bottom of the appliance can
cause corrosion. Fill the appliance with
salt before you start a washing
program to prevent corrosion.
Do these steps to fill the salt container:
1. Turn the cap anticlockwise to open the
salt container.
2. Fill the salt container with 1 litre of water
(only the first operation).
ppm mmol/l
0,7 - 1,8
< 70 < 0,7
Water hardness setting
manually
1
1
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and
C until the indicator lights of function
buttons A, B and C start to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator lights for function but-
tons B and C go off.
– The indicator light for function button
A continues to flash.
– The digital display shows the current
level.
Example: digital display shows
level 5.
6. Press the function button A one time to
increase the water softener level by one
step.
7. Continue pressing function button A un-
til the desired water softener level is
achieved.
8. Press the on/off button to save the op-
eration.
3. Use the funnel to fill the salt container
with salt.
electrolux 7
electronically
2
1)
1
=