Configure The Ftp Default Settings - Brother ADS-1000W User Manual

Scan Using the Control Panel

Configure the FTP Default Settings

You can set Passive Mode to Off or On depending on your FTP server and network firewall configuration.
By default this setting is On. You can also change the port number used to access the FTP server. The default
for this setting is port 21. In most cases these two settings can remain as the default (the example below uses
ADS-1500W).
1
Enter the name that you want to use for the profile of the FTP server. This name will be displayed in
Destination in Scan to Network Device from the Scan tab (ADS-1000W only)or on the LCD of the
machine (ADS-1500W only), and can be up to 15 characters.
2
The Host Address is the domain name of the FTP server. Enter the Host Address (for example
ftp.example.com) (up to 64 characters) or the IP address (for example 192.23.56.189).
3
Enter the Username that has been registered with the FTP server for the machine (up to 32 characters).
4
Enter the Password for access to the FTP server (up to 32 characters).
5
Enter the destination folder where your document will be stored on the FTP server (for example
brother\abc) (up to 60 characters).
6
Choose the file name you want to use for the scanned document. You can choose from seven preset
and two user defined file names. The file name that will be used for your document will be the file name
you selected plus the last 6 digits of the scanner counter plus the file extension (for example,
Estimate_098765.pdf).
6
6
119